Lace Front Wigs

III. Application Process

Application Process No. 1 — Using Glue1. With a small make-up brush, or Qtip, apply a thin layer of glue around the perimeter of your scalp, justbeyond the hairline. Certain glues must dry and become tacky for up to 15 - 20 minutes before bonding.

** DO NOT BOND LACE WIG TO WET GLUE. WIG WILL NOT STICK WELL.

Application Process No. 2 — Using Tape

1. Position lace wig on your head. For proper alignment, begin pressing down at the center point of your head with your finger. (The center point can be determined by parting hair down the middle and aligning with center of forehead.) Then going from one side to the other, press hair down firmly onto adhesive using a tail comb. If you make a mistake, do not panic, just use alcohol on a Q-Tip and place under lace between lace and skin to release and reapply.
2. Check hairline to touch-up any areas where wig is not applied. When application is completed, use silk scarf to tie down for at least 15-20 minutes to hold hair in place.

Tape is fast, considered by some as less messy, and simple to use.

1. Make sure skin and wig are clean and dry — free of all grease and oil.
2. Cut tape per directions. Usually, you can cut one piece of tape into two slimmer pieces.
3. Peel tape off of the side that will adhere to the unit.
4. Apply tape around the perimeter of the unit, remembering to firmly press down.
5. Position unit onto your head.
6. Then peel remaining protective paper from the side that will bond to your skin. Starting with the center and going from side to side, pressing down with a tail comb.
7. When application is complete, tie hairline down with silk scarf for a least 15-20 minutes.